North American Network Operators Group

Date Prev | Date Next | Date Index | Thread Index | Author Index | Historical

RE: Cisco and Juniper Inter-Operability Issues ???

  • From: Daniel Golding
  • Date: Sat Sep 01 08:07:51 2001

The OSPF issues with Junos have been long fixed, although they were once
quite nasty.

- Daniel Golding

-----Original Message-----
From: owner-nanog@merit.edu [mailto:owner-nanog@merit.edu]On Behalf Of
John Kristoff
Sent: Friday, August 31, 2001 4:59 PM
To: nanog@merit.edu
Subject: Re: Cisco and Juniper Inter-Operability Issues ???



Devon True wrote:
> Any gotchas we should watch out for and any tips/tricks? I read the
> NANOG archive and saw someone mention OSPF problems with Juniper and to
> run ISIS. Is that still the case?

I haven't seen any OSPF compatibility problems, including the use of
authentication and changes in the default reference-bandwidth between
Junipers and Cisco.  Tested using JunOS 4.4 and 4.3.

As far as the OC3c goes, You may want to preconfigure all the VPIs
you'll ever have in advance if you can.  Anytime you reconfigure them,
the Juniper does a reset of the SAR to reallocate memory to the VPIs.
This will cause all your ATM circuits on that interface to bounce.

If you setup your peers under a BGP group statement, you will also need
a 'peer-as' statement at the group level.  You can give it a
bogus/private one there just to satisfy the config.  I don't think they
have fixed this wasn't fixed as of JunOS 4.4.

And finally, 'commit confirmed' is your friend.  :-)

John